Extron electronic RGB 560 AKM - Manual (Page 4)

Extron Electronics, USA
1230 South Lewis Street, Anaheim, CA 92805
800.633.9876 714.491.1500
FAX 714.491.1517
USA
Extron Electronics, Europe
Beeldschermweg 6C, 3821
AH Amersfoort
+31.33.453.4040 FAX +31.33.453.4050
The Netherlands
Extron Electronics, Asia
135 Joo Seng Rd. #04-01,
PM Industrial Bldg.
+65.383.4400 FAX +65.383.4664
Singapore 368363
Extron Electronics Information
Extron
WEB ™: www.extron.com
Extron FAX ™: 714.491.0192
24-hour access—worldwide!
01-04
68-565-01
REV. A
Video
Gain ................................................ Unity (0.70V p-p), (0.725V
p-p) 50% peaking, (0.75V
p-p) 100% peaking
Bandwidth ...................................... 300 MHz (-3dB)
Video input
Number/signal type ........................ 1 analog RGBHV, RGBS,
RGsB, RsGsBs
Connectors
RGB 500 AKM ............................ 1 9-pin D male, MBC/LBC
cable or buffer
RGB 560 AKM ............................ 1 15-pin HD female
Minimum/maximum levels.............. Analog—0.3V to 1.5V p-p
with no offset
Impedance ...................................... 75 ohms or High Z, switchable
(set to 75 ohms if no local
monitor is connected)
Horizontal frequency ...................... Autoscan 15 kHz to 130 kHz
Vertical frequency ............................ Autoscan 30 Hz to 120 Hz
Return loss ...................................... -30dB @ 5 MHz
Maximum DC offset ...................... 4.0V
Video output
Number/signal type ........................ 1 analog RGBHV, RGBS,
RGsB
Connectors ...................................... 5 BNC female
RGB 560 AKM .............................. 1 15-pin HD female for
buffered local monitor output
Minimum/maximum levels ............ 0.70V to 0.75V p-p with no
offset and 0.7V p-p input
Impedance ...................................... 75 ohms
Return loss ...................................... -30dB @ 5 MHz
Sync
Input type ...................................... RGBHV TTL (±), RGBS TTL
(-), RGsB 0.3V (-), RsGsBs
1.3V (-)
Output type ........................................ RGBHV (±), RGBS(-), RGsB (-)
Input level ...................................... 2V to 5.5V p-p with ±0.3VDC
offset (max.)
Output level .................................. 4V to 5V p-p
Input impedance ............................ 10 kohms
Output impedance .......................... 75 ohms
Max. input voltage .......................... 5.7V p-p
Max. propagation delay .................. 48 nS
Max. rise/fall time............................ 3.5 nS
Polarity
AKM models ................................ RGBHV: Polarity follows input
when RGBHV is input and the
sync polarity switch is set to
Off. Sync polarity is negative
if the sync polarity switch is set
to On.
RGBS, RGsB: Negative
Audio
Gain........................................................ Unbalanced 0dB, balanced +6dB
Frequency response ........................ 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................ 0.03% @1 kHz, 0.3% @ 20
kHz at rated maximum output
drive
S/N ................................................ >90dB at rated maximum
output (14dBm), balanced
Stereo channel separation ................ >95dB @ 1 kHz to 20 kHz
Audio input
Number/signal type ........................ 1 PC level stereo, unbalanced
Connectors ...................................... 1 3.5 mm stereo jack, 2
channel; tip (L), ring (R),
sleeve (ground)
Impedance ...................................... 10 kohms, DC coupled
Maximum level .............................. +8.5dBu, (unbalanced) at stated
%THD+N
Audio output
Number/signal type ........................ 1 stereo (2 channel), balanced/
unbalanced
Connectors .................................... 1 3.5 mm stereo captive screw
connector, 5 pole, for left and
right output
Impedance ...................................... 50 ohms unbalanced, 100
ohms balanced
Gain error........................................ ±0.1dB channel to channel
Maximum level (600 ohm) .............. > +14dBm, balanced at stated
%THD+N
General
Power .............................................. 12 to 24VAC or VDC, 0.35 A,
5 watts, external (Order the
power supply separately,
part #70-055-01.)
Enclosure type ................................ Ackermann GES9B
Enclosure dimensions — RGB 500 AKM, RGB 560 AKM
Interface .......................................... 3.1" H x 8.1" W x 1.6" D
(7.8 cm H x 20.6 cm W x
4.1 cm D) (Depth excludes
connectors and knobs.)
Shipping weight .............................. 3 lbs (1.4 kg)
Vibration ........................................ ISTA/NSTA 1A in carton
(International Safe Transit
Association)
Approvals ........................................ UL, CE
MTBF ............................................ 30,000 hours
Warranty ........................................ 2 years parts and labor
Part Numbers
RGB 500 AKM .............................. 60-313-01
RGB 560 AKM .............................. 60-314-01
S
PECIFICATIONS
Copyright © 2001 Extron Electronics. All rights reserved. All trademarks mentioned are the property of their respective owners.