Logitek Electronic Systems JetStream Audio Networking Platform - Manual (Page 19)

If integrating the JetStream with an AoIP system made by another manufacturer, connect an AES
output to the External Sync input of one JetStream as described above and set this unit as the
master. The red and green lights will be lit on the rear and/or front of the unit. Set the other
JetStreams as slaves. The green lights will be lit on those units. This will ensure that all AoIP devices
are rate locked.
Contact support for assistance with turning on the Master/Slave busses.
Find Me Button
The Find Me button is used to put the JetStream into Idle mode, where the JetStream stops
processing audio and waits for a new configuration to be uploaded to the DSP card.

See Chapter 6 for further details on Resets
“Open” Control Protocol
The control protocol of the JetStream MINI is “open”. If a user wishes to write software control or
to interface other devices through software control, contact Logitek Electronic Systems, Inc. for a
copy of the protocol.
Surface Connections – First Generation (s/n 1-199)
Control Surfaces (Audio Consoles) and Control Panels (Guest Turrets and router control heads)
connect via RS-485 to the JSM-DSP card, which is labeled as Surface. The ports are labeled 1 to 4,
with the first port at the top.
Logitek JetStream MINI Reference Manual 19