LW Scientific OmniVID - Manual (Page 8)

When the microscope is changed to a different magnification, the
observation setting will be changed and should be readjusted to
optimum.
The number in the rectangle located in the centre of the LCD is the
focusing parameter, the bigger value of this parameter represents a
better focusing quality.
Snapshot
Now the microscope is ready to take microscopic images. However, the
focus point and the brightness setting need to be adjusted according to
the sample under observation. When everything is ready, press
「SNAP」
to record an image, and it will be stored on the SD card. To avoid
vibrations during recording, it is highly recommended to use the remote
control or USB control to take snapshot.
Camera Modes
Camera has three different operation modes, which are ‘Camera’, ‘Video’ and
‘Play’ mode respectively. The initial mode when the camera is just switched on
is ‘Camera’, and it can be changed to other modes by the following steps:
First of all, make sure that no menu function is selected
Press
「MODE」button once and the LCD will display three mode
options. You can change to other modes by continuing to press
「MODE」. Press「OK」button to select the mode or wait for 2 seconds
to select the mode automatically.
Press
「UP」to change to 「Camera」mode, and「OK」to select, or
wait for 2 seconds.
Press
「LEFT」to change to 「VIDEO」mode, and「OK」to select, or
wait for 2 seconds.
Press
「RIGHT」to change to 「PLAYBACK」mode, and「OK」to select,
or wait for 2 seconds.
Snapshot and Video
In
「VIDEO」 mode, video images can be recorded on the SD card, but it is
7