Markbass Super Synth - Manual (Page 4)

04
4. FUNCTION OVERVIEW
GAIN (1) - Controls the level of input into the pedal, from -10 ÷ +16dB.
CUT FREQ / OCT -1 (2) - In Synth mode, this knob controls the cutoff frequency, from 70Hz to 14000Hz. In Octaver mode, it con-
trols the volume level of the lower octave (one octave below your dry signal).
TONE / OCT +1 (3) - In Synth mode, this knob allows you to select from seven (1-7) factory presets of Detune, Amp and Pan
settings of the oscillators, and one user preset (8). In Octaver mode, it controls the volume level of the upper octave (one octave
above your dry signal).
LEVEL/DRY (4) - In Synth mode, this switch controls the output level from the pedal. In Octaver mode, it’s a volume knob for your
dry signal.
PRESETS (5) – This switch lets you scroll through the 12 presets in the pedal
True Bypass Switch (6)* - Toggles between “on” and bypass mode. The LED illuminates when the synth/octaver effect is active.
“Software Instructions” to find out how to create and store presets on your computer.
DC IN (11) - External power supply connection: 12VDC (550 mA minimum) PSU.
Note: this switch also allows you to restore the pedal to its factory default setting, cancelling all modifications made with the
software. To restore the factory default settings, press this button and hold it while you connect the pedal to its power source.
*True Bypass
When the pedal’s controls are ‘off’, your signal goes directly from the input jack to the output jack without any degradation of audio quality.
SYNTH/OCTAVER Switch (7) - This switch toggles between Synth and Octaver modes.
DISPLAY (8) -The digital display is easy to read and always identifies what effect is active.
5. CONNECTIONS
1/4” INPUT jACk (9) - Connect your instrument to the input jack. Make sure your amp is off and ensure that the volume is turned down before making connections.
1/4” OUTPUT jACk LEFT/MONO (10) - Output for a mono effect signal or, when both outputs are connected, the left channel of
the stereo effect signal.
1/4” OUTPUT jACk RIGHT (13) - Output of the right channel when running stereo.
CONTROL (12) - The USB connection allows you to modify the parameters on your computer using the supplied Markbass
software, and then store your favorite settings back on the pedal to have them at your disposal whenever you need them! See