Markbass MoMark Black 800 - Manual (Page 2)

1. IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions;
2) Keep these instructions;
3) Heed all warnings;
4) Follow all instructions;
5) Do not use this apparatus near water;
6) Clean only with dry cloth;
7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions;
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat;
9) Only use attachments/accessories specified by the manufacturer;
10) Refer all servicing to qualified service personnel. Servicing is required when the apparatuses has been damaged in any way, such as when the power supply
cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, or when the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped;
11) “Warning: to reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture; and objects filled with liquids, such as vases, should not
be placed on this apparatus”;
1. PRÉCAUTIONS D’EMPLOI
1) Lire ces instructions;
2) Conserver ces instructions;
3) Suivre tous les conseils d’utilisations;
4) Suivre toutes les instructions;
5) Ne pas utiliser cet appareil au bord de l’eau;
6) Nettoyer uniquement avec un chiffon humide;
7) Ne pas bloquer le système de ventilation. Installer conformément aux instructions du fabricant;
8) Ne pas installer l’appareil près d’une source de chaleur tel qu’un radiateur, un fourneau, ou bien un autre appareil qui produit de la chaleur;
9) Utiliser uniquement les accessoires recommendés par le fabricant;
10) S’adresser à un service assistance agréé si l’appareil a subi des dommages, si le cordon d’alimentation ou la fiche a été endommagé, si un liquide a été
renversé sur l’appareil ou bien si un object est tombé dans l’appareil, si ce dernier a été exposé à la pluie ou à l’humidité, s’il ne fonctionne pas correctement ou
s’il est tombé;
11) “Avertissant: pour réduire le risque du feu ou de décharge électrique, n’exposez pas cet appareil à la pluie ou l’humidité et les objets remplis de liquides; tels
que des vases, ne devraient pas être placés sur cet appareil”;
MORE INFORMATION
For warranty and service information, please contact your local Markbass distributor (contact information available at www.markbass.it). For more technical
information, please visit us at www.markbass.it and fill out the form on the Contact Us page. We hope you enjoy your amp and use it to make great music!
“The Lightning Flash with arrowhead symbol within an equilateral triangle,
is intended to alert the user to the presence of uninsulated “dangerous
voltage” within the product enclosure that may be of sufficient magnitude to
constitute a risk of shock to persons.”
“The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the product.”
1
1
1
5
5
2
3
4
2. MOMARK MODULE ASSEMBLY INSTRUCTIONS
Prior to installing and/or removing modules, be sure to turn the
unit off AND unplug it from the power source.
Do not connect the unit to a power source unless all three
modules are installed in the amp frame.
Insert the tool (1) supplied with the modules into the two
holes on the front panel of the module.
Slide each module right-side-up into the
amp frame. Be careful to insert each
module into its proper slot!
The PRE module goes in the left slot (2);
the the EQ module goes in the center slot (3);
and the MASTER module in the right slot (4).
For each module, fasten the two corresponding upper screws
and two lower screws (5). To disassemble a MoMark and remove
the modules, repeat the operations above in inverse
order.