Electrolux 80860 i - Manual (Page 26)

Operating Instructions
26
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower rack, an intelligent electronic system adjusts
the amount of water and the duration of the wash programme to the
number of dishes. By this means it is possible to wash only a few dishes
quickly and economically. At half load (6 place settings), up to 2 litres
of water and 0.2 kWh of electricity are saved.
Switching Off the Dishwasher
Switch the dishwasher off when the multi-display indicates “0“ for the
remaining programme time and END is illuminated on the programme
progress display.
If the signal tone for the end of the washing programme is enabled, a
continuous tone indicates the end of the programme for 10 seconds. If
the dishwasher is not switched off, the continuous tone is repeated
twice after a few minutes.
0 1. Press the ON/OFF button. All indicators go out.
1 Hot steam may escape if the door is opened immediately after the end
of the programme.
2. Open the door carefully, as steam may escape.
Emptying the Dishwasher
3 • The dishes should be allowed to cool down before removing them
from the appliance, as hot dishes can be sensitive to knocks.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• Empty the lower rack first, then the upper rack. In this way you will
avoid any water left on the upper rack dripping onto the dishes in the
lower rack and causing water spots.