Dimm replacement procedure, Removing the existing dimm, Installing the dimm – Enterasys Networks DFE-256MB-UGK User Manual

Page 3: D to, Dimm replacement, Procedure, Below

Advertising
background image

DIMM Replacement Procedure

PN 9033946

Page 3 of 5

DIMM Replacement Procedure

Although the following replacement procedure describes how to replace a DIMM in an angled
connector, the procedure also applies to DIMM replacement in a vertical connector.

Removing the Existing DIMM

Refer to

Figure 1

and proceed as follows:

1.

Push the connector arms

➀

away from the DIMM

➁

to release it from the connector

➂

.

2.

Remove the module from the connector

➂

.

Figure 1 Removing the Existing DIMM

Installing the DIMM

To install the memory module, refer to

Figure 2

and proceed as follows:

1.

With the connector arms

➀

set in the open position, insert the DIMM

➁

between the

connector fingers

➂

.

2.

Push the memory module into the connector until the tabs on the two connector arms pull in
towards the DIMM alignment notches

➄

.

Caution: Observe all antistatic precautions when handling sensitive electronic equipment.

➀

Connector arms

➁

DIMM

➂

Connector

В

А

А

Б

Caution: Observe all antistatic precautions when handling sensitive electronic equipment.

Caution: The connectors on different DFE modules may have the keys inside the connector
reversed. To prevent damaging the DIMM and main pc board, make sure that key slots

➃

are

positioned to match those in the connectors. Otherwise, the DIMM and pc board will be damaged.

Advertising