Enfora 600/650 - Manual (Page 10)

Installing the Treo Smartphone into the Enfora® Wi-Fi® Adapter
Attach the updated Battery Cover to the Treo 650
These instructions apply only to the Treo 650 Smartphone. If you have the Treo
Smartphone 600, please skip these instructions, and proceed to Attach the Enfora® Wi-
Fi® Adapter to the Treo 600/650.
1. If you haven’t replaced the Battery Door with the enclosed Battery Door, grasp
your Treo 650, and look at the Battery Door on the back of the unit.
2. Press in the elliptical button, just above the Battery Door, to release the current
Battery Door. Slide the door down approximately .1” (one-tenth of an inch) to
remove it from the Treo 650.
3. Place the Updated Battery Door in the position of the existing one, and slide the
Door up until it “seats” in place.
Attach the Enfora® Wi-Fi® Adapter to the Treo 600/650
These instructions apply to the Treo 600 and Treo 650 (with the updated battery cover
attached to the Treo 650).
1. Ensure the Enfora® Wi-Fi® Adapter is turned off.
2. Hold the Enfora® Wi-Fi® Adapter upright in one hand.
3. Grasp the edges of the Treo and slide the Treo into the bottom portion of the
Enfora® Wi-Fi® Adapter.
4. With the Treo positioned at about a 5º to 10º from the inner surface of the
Enfora® Wi-Fi® Adapter; push the Treo, gently down, onto the mating connector
of the Enfora® Wi-Fi® Adapter. You will hear/feel a click as the Enfora® Wi-
Fi® Adapter connector is seated into the Treo.
5. While grasping the Enfora® Wi-Fi® Adapter with one hand (depress the Lock/
Release Button down with the index finger), press the Treo flat into the Enfora®
Wi-Fi® Adapter, with your other hand, seating the short rib/ribs, near the Lock/
Release Button, into the receptacles in the back of the Treo. Release your hold on
the Lock/Release Button.
6. The Enfora® Wi-Fi® Adapter is now attached to the Treo.
Lock/Release Button
WLN1501/WLN1502 Wi-Fi Adapter Page 7
Copyright, 2005 Enfora, Inc.