Parkside PBS 600 A1 - Manual (Page 41)

41 GB/MT
Preparing for use / operation
Connection:
j Push the adapter for external vacuum extraction
12 into the adapter port 9 . If it is necessary to
use the reducer piece 13 , push the reducer piece
into the adapter for external vacuum extraction 12 .
j Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
12 with the reducer piece 13 ,
if used.
Removal:
j Pull off the dust extraction device hose.
j Pull off the adapter for external vacuum extrac-
tion
12 (with the reducer piece 13 , if used).
Q
operation
Q Switching on and off
When operating the belt sander you can select
between intermittent or continuous operation mode.
To switch on intermittent operation mode:
j Press the on / oFF switch 3 .
To switch off intermittent operation mode:
j Release the on / oFF switch 3 .
To switch on continuous operation mode:
j Press the on / oFF switch 3 , and keep it
pressed, then press the locking knob 4 .
To switch off continuous operation mode:
j Press and then release the on / oFF switch 3 .
Q Selecting the correct rotational
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel
1 even whilst the sander is running.
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the best
speed by carrying out a small test. The following
table lists some recommended values to help you
determine the optimum speed.
Material / type of
work Softwood
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 240
Preselected rotation
speed
high (5-6)
Material / type of
work Hardwood
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 180
Preselected rotation
speed
high (5-6)
Material / type of
work Chipboard
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) 150
Preselected rotation
speed
high (5-6)
Material / type of
work Removing paint /
varnish
Coarse finish
(Grit grade)
60
Fine finish (Grit grade) ––
Preselected rotation
speed
high (5-6)
Material / type of
work Sanding varnish
Coarse finish
(Grit grade)
150
Fine finish (Grit grade) 320
Preselected rotation
speed
low (1-2)
64748_Bandschleifer 600 W_content_LB5.indd 41 01.04.11 14:20