Parkside PPHSS 730 SE - Manual (Page 42)

41 GB/MT
Preparing for use / Operation / Maintenance and cleaning
Q
Attaching the guide fence
The guide fence 19 can be attached on the left or
right side of the device (see Fig. A).
j Release the two locking screws of the fence
guide openings 15 .
j Slide the guide fence 19 into the fence guide
openings 15 .
j Retighten the two locking screws.
Q
Connecting the vacuum
sawdust extraction device
j Insert the dust extraction spout 7 into the
vacuum extraction duct 8 until it engages.
j Connect a vacuum device approved for the
extraction of sawdust and splinters to the dust
extraction spout
7 (see Fig. C).
Q
operation
Q
Setting the cutting angle
j Release the clamp screw 11 using the Allen
key 20 .
j Set the cutting angle 0° / 15° / 30° / 45°
(left / right) on the base plate 9 . The embossed
marking for each recessed line indicates the
cutting angle setting. The housing has a stop
pin
21 (see Fig. B) which must engage in the
appropriate recessed line.
j
Tighten the clamp screw 11 using the Allen
key 20 .
Q
Setting the speed
j
Set the desired speed using the oscillation
speed setting wheel 4 .
j
If possible always determine the optimum
setting beforehand by carrying out a
practical test.
Q
Setting the pendulum action
You can set the pendulum movement of the saw
blade
14 using the pendulum action switch 12 . By
having no pendulum action (setting “0”) you can
produce fine, clean cut edges. Turn off the
pendulum action for thin workpieces.
With the pendulum action activated (settings 1 – 3)
you can cut through the workpiece at increasingly
quicker rates.
j If possible always determine the optimum set-
ting beforehand using a practical test.
Q
Switching on / off
DAnGEr! Before connecting to the mains
plug check that the mains circuit supplies
230 V ~ 50 Hz and is fitted with a 16 A fuse or
cut-out in accordance with the regulations!
Switching on:
j Push the On / OFF switch 2 into position “I”
and ensure it engages.
Switching off:
j
Press the rear part of the On / OFF switch 2 .
Q
Maintenance and cleaning
Q
Maintenance
j Replace the saw blade 14 as soon as its teeth
become blunt and it starts to produce defective
saw cuts.
Q
Cleaning
j Carry out that cleaning of the device when you
have finished sawing.