Flap discs for metal, Other accessories, Adjusting the disc guard cover – Parkside PWS 125 A1 User Manual
Page 64
64 GB
Use of accessories / Maintenance and cleaning / Service / Warranty
Use of accessories
ø 125 x 22.2 mm
to max. 6 mm thick
(depressed centre)
12000 rpm
80 m / sec
Q
Flap discs for metal
Dimensions:
ø 125 mm
Speed:
min. 12000 rpm
Q
Other accessories
You can also use abrasive consumables and tools
complying with the following technical specification:
Spindle thread:
M14
Speed:
min. 12000 rpm
Backing plate for grinding discs
Dimensions:
ø 115 mm / 125 mm
Grinding discs for wood / masonry attached
with hook and eye fixings
Dimensions:
ø 115 mm / 125 mm
Note! These may only be used in combination
with a backing plate!
Cup brush, crimped wire
Dimensions:
ø 75–100 mm
Speed:
min. 12000 rpm
Cup brush, twisted wire
Dimensions:
ø 75 mm
Speed:
min. 12000 rpm
Cup brush, knotted wire
Dimensions:
ø 115 mm
Speed:
min. 12000 rpm
Q
Adjusting the disc guard cover
DANGER OF INJURy!
Pull the mains plug out of the mains socket
before you carry out any task on the device.
In order to adjust the safety cover
5
, one does
not need to remove the screws
12
but just loo-
sen them.