Eton FR250 - Manual (Page 4)

USING AN AC ADAPTER (NOT INCLUDED)
FR250 OPERATION MANUAL
4
1. Open the battery compartment; it slides downward with firm
pressure at center of hinge.
2. Connect the battery pack.
1. Rechargeable battery pack (included).
2. 3 AA batteries (not included).
3. AC adapter/charger (not included).
4. Continually turning the crank, even with no batteries installed.
1. Switch the power selector to the OFF position.
2. Turn the dynamo-crank clockwise or counter-clockwise about 2
turns per second.
3. After charging, select the DYNAMO/ADAPTOR position for power.
While charging, the red LED charging light illuminates.
1. Open the battery compartment.
2. Install 3 AA batteries, observing polarity diagram.
3. For power, set the power selector switch to the BATTERY position.
INITIAL SETUP
1. Plug the adapter into the DC 4.5 V socket.
2. For power, set the power selector switch to the
DYNAMO/ADAPTER position.
1. Set power selector switch to DYNAMO/ADAPATOR.
2. While continually turning the dynamo crank, radio stations can
be tuned and the lights and siren function.
Because cell phone batteries vary in their current ratings, we cannot
specify charging rates or usage time. 10 to 15 minutes of cranking
may result in 1 or more minutes of talk-time.
1. Set power selector switch to OFF position.
2. Plug the cell phone charging cord into the Phone Charge socket.
3. Select the correct charging tip for your phone.
4. Plug charging tip into the charging cord and into the phone’s
charging socket.
5. Rotate the dynamo crank.
Turn it on with the POWER switch.
1. Select the BATTERY position when using AA batteries.
2. Select the DYNAMO/ADAPTER position when powering via the
AC adapter or internal, rechargeable Ni-MH battery pack.
3. To turn off, set power selector switch to OFF.
POWER SOURCES
CHARGING THE BATTERY PACK
EMERGENCY OPERATION WITH NO POWER SOURCE
CELL PHONE CRANK CHARGING
AA BATTERY OPERATION
5
TURNING THE RADIO ON AND OFF