Introduction, Rating label location, Pellet quality – Enviro Mini A User Manual

Page 3

Advertising
background image

3

Introduction

* This manual is designed for the home owner in conjunction with the technical manual. *

R

ATING

L

ABEL

L

OCATION

:

The rating label is located on the back of the ash pan cover.

P

ELLET

Q

UALITY

:

Pellet quality is important, please read the following:

Your enviro pellet stove has been designed to burn wood pellets only. Do not use any other

type of fuel, as this will void any warranties stated in this manual.

The performance of your pellet stove is greatly affected by the type and quality of wood

pellets being burned. As the heat output of various quality wood pellets differs, so will the

performance and heat output of the pellet stove.

CAUTION: It is important to select and use only pellets that are dry and free of dirt or any impurities

such as high salt content. Dirty fuel will adversely affect the operation and performance of the unit

and will void the warranty. The Pellet Fuel Industries (P.F.I.) has established standards for wood pellet

manufacturers. We recommend the use of pellets that meet or exceed these standards. Ask your dealer

for a recommended pellet type.

P.F.I. PELLET STANDARDS:

Fines (fine particles)......1% maximum through a 1⁄8” screen

Bulk Density..................40 pound per cubic foot minimum

Size..............................1⁄4” to

5

/

16

” diameter 1⁄2 – 11⁄2” long maximum

Ash Content..................1% maximum (Premium grade)

..................3% maximum (Standard grade)

Moisture Content...........8% maximum

Heat Content.................approximately 8200 Btu per pound minimum

ASH: The ash content of the fuel and operation of your stove will directly determine the frequency of

cleaning. The use of high ash fuels may result in the stove needing to be cleaned daily. A low ash fuel

may allow longer intervals between cleaning.

CLINKERING: [clinkers are silica (sand) or other impurities in the fuel that will form a hard mass during

the burning process]. This hard mass will block the air flow through the Burn Pot Liner and affect the

performance of the stove. Any fuel, even approved types, may tend to clinker. Check the Burn-Pot Liner

daily to ensure that the holes are not blocked with clinkers. If they become blocked, remove the liner

(when the unit is cold) and clean/scrape the clinkers out. Clean the holes with a small pointed object if

required. Refer to the section Routine Cleaning and Maintenance.

PELLET FEED RATES: Due to different fuel densities and sizes, pellet feed rates may vary. This may

require an adjustment to the slider damper setting or to the auger feed trim setting on low.

Since Sherwood Industries Ltd. has no control over the quality of pellets that you use, we assume no

liability for your choice in wood pellets.

Store pellets at least 36” (1 m) away from the pellet stove.

Advertising