Emerson Process Management Control Wave SCADA RTU - Manual (Page 4)

Product Data Document
420DS-12A
October 1, 2007 - Page 4
Integrated Pump Control
SCADA RTU
Website: www.EmersonProcess.com/Remote
Remote Automation Solutions
The initial configuration setup is presented in a step-
by-step procedure using a question and answer for-
mat. Once familiar with the procedures, individual
configuration pages can easily be accessed rather
than using the Q & A format.
A station overview display is also provided to show
pump run status, local/remote operation, and instan-
taneous values of pressure, flow and level.
Setup and configuration may also be performed
from the integral display/keypad on the ControlWave
PLC/RTU SCADA package or via the SCADA
system host HMI. All configuration parameters are
made available to OPC servers for compatibility with
our OpenEnterprise SCADA software as well as
third party SCADA software packages.
The configuration pages allow you to set the com-
munication address and parameters, select station
control mode parameters, enter setpoints and alarm
limits, modify zero and span for analog inputs, add
permissives and interlocks, and perform pump
startups.
Q & A Configuration
Configuration Page
I/O Configuration
Loop Control Page