Installing the batteries, External input mode, Mobile connection – Emerson EWC0903 User Manual

Page 10

Advertising
background image

- 10 -

EN

9J27

INSTALLING THE BATTERIES

1)Open the battery compartment cover by pressing

the cover on the remote unit in the direction of the
arrow.

2)Insert 2 “AA” penlight batteries into the battery

compartment in the direction indicated by the
polarity (+/-) markings.

3)Replace the cover.

EXTERNAL INPUT MODE

When using an external input signal (another VCR or
video camera), connect the player’s audio/video out-
put cables to the AUDIO IN/ VIDEO IN jacks of
your TV/VCR. Then press the CHANNEL K or L
button until “AUX” appears on the screen.

AUX

MOBILE CONNECTION

NOTES:

•

Be sure your vehicle has a 13.2-volt (12-volt), neg-
ative-ground electrical system.

•

Be sure you use only the supplied car battery cord.
Using another cord could damage the TV/VCR.

•

Be sure the socket is free of ashes and other debris.

•

Be sure to push the car battery cord’s plug com-
pletely into the cigarette-lighter socket.

•

Always unplug the car battery from the cigarette-
lighter socket before you unplug it from the
TV/VCR.

•

You must disconnect the car battery cord from the
TV/VCR before you can use the AC power.

•

Be sure to replace the fuse with only the same type,
5A, 250V.

•

Be sure the AC cord is wound as shown below.

WARNING: The driver should never watch
the TV/VCR while operating a motor vehicle.

CAUTION:

•

When used in moving vehicle, be sure that
the unit is secure at all the times to prevent
injury. Consult a professional installer.

•

If you use the TV/VCR with the vehicle’s
engine off, recharge the vehicle’s battery
after about every 4 hours of use to prevent it
from running down. After you finish using
the TV/VCR be sure you unplug the car-bat-
tery cord from the cigarette-lighter socket.

DC13.2V

ANT.

VHF/UHF Combination
Mobile Antenna
(Not supplied)

To the vehicle's
cigarette-lighter socket

Car battery cord
(Supplied)

1) The supplied indoor antenna is adequate when

your vehicle is stationary. For best reception on
the road, use a high-quality VHF/UHF mobile TV
antenna.

2) Attach the car battery cord to the DC13.2V(12V)

connector on the back of the TV/VCR. Then, con-
nect the other end to your vehicle’s cigarette-
lighter socket.

T4403UD.QX33 02.12.24 4:47 PM Page 10

Advertising