Curtis PLED3204A - Manual (Page 16)

OPERATION
-15-
1). Air/Cable: Select Air TV signal or cable TV signal.
2). Auto Scan: If you selected Air on Air/Cable selection,
scanning all TV channels is required prior to starting
watching the TV programs. Press the button, and you
will see the following menu.
Select“yes”and press the ENTER button.
You will see the following screen that shows
progress of Auto Scan.
3). Favorite: Press button to choose/delete the
favorite channel .
4). Show/Hide: Press button to display or hide
the current channel.
5). Channel NO.: Display the current channel number.
6). Channel lable: Press button to edit the current
channel name.
7). DTV signal: Display DTV signal intension. It can't be
selected or adjusted.
Transparency 25%
Menu Language English
Select Adjust Menu Exit
< >
< >
3.5 VGA Settings: This is available only in PC Mode.
1).H-Pos:Adjust the horizontal position of the screen.
2).V-Pos:Adjust the vertical position of the screen.
3).Clock: Fine tune the screen width.
4).Phase: Fine tune the phase of the screen.
This adjustment is not required in normal case.
5).Auto: Auto adjust to fit the screen.
Press button to select VGA Settings and press
button. The screen will display as follows:
Select Adjust Menu Exit
H-pos
V-pos
Clock
Phase
50
Auto
50
50
50
>
4. Channel MENU
The fourth item of the MENU is Channel MENU.
You can adjust digital and analoge TV Channel.
Press to select and press to adjust.
Select Adjust Menu Exit
Air/cable
Auto Scan
Air
Favorite
Show/Hide
Channel NO.
Channel Lable.
DTV signal: Good
2-1
< >
< >
>
>
>
>
Select Adjust Menu Exit
Are you sure?
NO YES
Press“ENTER”Key To Select
Select Adjust Menu Exit
R F CH: 4
Found: 4
Analog: 1
Digital: 3
3.4 Menu Settings
You can adjust Menu Settings here.
Press to select. Press to adjust. Press MENU
to exit.