Curtis SDVD8706 - Manual (Page 8)

1.Connect the unit to the power;
2.Open the unit and adjust the monitor to the best position for viewing.
3.Turn on the unit by sliding the ON/OFF switch to ON.
4.Open the disc door and insert a disc into the door with the label side facing up.
5.Close the disc door. The unit will load the disc and start playing.
6.Press“ ”once to stop playback;press“ ”to resume playback from the point where
you stopped; press“ ”twice to stop playback completely.
7.when the playing is finished, please turn off the power by sliding ON/OFF switch to OFF.
Play/pause
Menu Title
Cursor button
ENTER
Play DVD disc with title or chapter menu
Playing disc of DVD,CD,MP3.
MP3
MP3
CD
CD
Pause during playback
Basic Operation
DVD
DVD
Note:
When at pause,stop,or no disc, in about 3 minutes
the unit will be protected; press any button to exit.
For some DVD disc with Title or chapter menu,
press “MENU” button to enter menu page, and use
direction button to select, Press “ENTER” to confirm.
During playback, press “ ” to pause; press it
again to resume playback.
13 12
1
2
CR2025 CR2025
Please put the battery into the remote control as per below illustration.
When using remote control,make sure the infrared window is pointed to infrared receiving
window of the machine.The distance between machine and remote control must be within
3 metres.Please refer to the following illustration.
The Use of Remote Control
Note:
1. To avoid falling off or place near damp environment.
2. To avoid infrared receiving window of the unit being under direct sunlight.
3. Please use a new battery to replace old one if the remote control doesn't work.
0 30 0 30
MUTE
OK