Epson Stylus NX400 - Manual

Epson Stylus ® NX400 Series
Start Here
9 Press the OK button to charge the ink. Charging takes about
2½ minutes.
Caution: Don’t turn off the NX400 Series while it is charging or you’ll
waste ink.
Unpack
If anything is missing, contact Epson as described on the back.
Caution: Do not open the ink cartridge package until you are ready to install
the ink. Cartridges are vacuum packed to maintain reliability.
Canada only: For French speakers, remove stickers from the backing sheet
and place over corresponding text on the control panel.
1
3 Squeeze the edge guide and slide it left.
Tip: If the feeder guard is in the way, flip it forward.
4 Load paper against the right edge and underneath the tab.
Note: Don’t load the paper sideways.
5 Slide the edge guide over.
Turn on the NX400 Series
1 Connect the power cable.
Note: Do not connect to the computer at this time.
2 Press the On button.
Load paper
1 Open the paper support and pull up the extensions.
2 Open the output tray, pull out the extensions, and raise the stopper.
5
2
8½ 11
4 6
Change your language
You can change the language that appears on your LCD display screen
from English to French, Spanish, or Portuguese.
1 Press Setup.
2 Press to select Maintenance, and press OK.
3 Press to select Language, and press OK.
4 Press or to select your language, and press OK.
4
Install cartridges
Note: Do not load paper yet.
1 Lift up the scanner.
2 Open the cartridge
cover.
3 Shake the ink cartridges,
then unpack them.
4 Remove only the yellow tape from each cartridge.
Caution: Do not remove
any other seals or the
cartridge may leak.
5 Insert the cartridges in the holder for
each color.
6 Press each cartridge down until it clicks.
7 Close the cartridge cover. Press down until
it clicks.
8 Lower the scanner.
3
(Included for Canada only)