Operation, Hob burners control knobs, Lighting the burners – Electrolux U30280 35772G User Manual

Page 6: Using the wok stand

Advertising
background image

6

Burner

minimum

maximum

diameter

diameter

Triple-crown (ultra-rapid)

160 mm

260 mm

Large (rapid)

160 mm

240 mm

Medium (semi-rapid)

120 mm

220 mm

Small (auxiliary)

80 mm

160 mm

As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid
simmering.
If you use a saucepan which is smaller than the recommended size, the flame will spread
beyond the bottom of the vessel, causing the handle to overheat.
Take care when frying food in hot oil or fat, as the overheated splashes could
easily ignite.
If the control knobs become difficult to turn, please contact your local Service Force
Centre.

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan

on the pan support.

To light a burner, turn the relevant knob anticlockwise to

maximum position (

), then push it down to ignite the

burner. Upon ignition, adjust the flame as required.

If the burner does not ignite, turn the control knob to zero,

and try again.

When switching on the mains, after installation or a power

cut, it is quite normal for the spark generator to be activated automatically.
In the absence of electricity, ignition can occur without the electrical device; in this case, approach

the burner with a flame, push the relevant knob down and turn it anti-clockwise until it reaches the

“maximum” position.

Operation

Using the Wok Stand

A wok stand is provided to enable you to use a round

bottomed wok on the hob. The wok stand must only be

used on the central burner, and should not be used with

any other type of wok or pan. When fitting the wok stand,

ensure the recesses in the frame fit securely onto the

bars of the pan supports, as shown in figure 3.

Fig. 3

Fig. 2

FO 0204

A - Burner cap
B - Burner crown
C - Ignition electrode

Advertising