Enterasys Networks 5H1XX - Manual (Page 26)

Management Terminal Setup
2-2 Local Management Requirements
To connect the switch module to a PC or compatible device running the VT terminal emulation,
proceed as follows:
1. Connect the RJ45 connector at one end of the cable (supplied in the kit) to the COM port on the
switch module.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB9 adapter (supplied in
the kit).
3. Connect the RJ45-to-DB9 adapter to the PC communications port.
Figure 2-1 Management Terminal Connection
2.1.2 Management Terminal Setup Parameters
Table 2-1 lists the setup parameters for the local management terminal.
NOTE: If using a modem between the VT compatible device and the COM port of the
switch module, use the appropriate connector included in the console cable kit. Refer to
the modem manufacturer’s information for proper operation and setup of the modem.
The 5H102-48 module is shown in Figure 2-1 as an example.
RJ45 COM Port
RJ45-to-DB9
PC Adapter
UTP Cable
With RJ45
Connectors
PC
3583_01
4 5 6 7 1 2 3
FAST ENET 5H102-48
GROUP
GROUP SELECT
RESET
COM
CPU
11X
1X
G R O U P
1
23X
13X
G R O U P
2
35X
25X
G R O U P
P
3
47X
37X
G R O U
4
GROUP
SERIES
E5
5C105-X 5C105-X