Enterasys Networks 5H1XX - Manual (Page 46)

Changing the Network Configuration
6-4 Management Setup Menu Screens
6.2.1 IP Configuration
Use the IP Configuration screen ( Figure 6-3 ) to set the bootup option, or configure the switch’s IP
parameters. The screen shown below is described in the following table.
Figure 6-3 IP Configuration Screen
Parameter Description
IP Configuration Used to set the bootup option, or configure the switch’s IP
parameters.
IP Connectivity Test (Ping) Used to test IP connectivity (Ping) to a specified device.
HTTP Configuration Used to enable the Web Agent.
MAX Number of Allowed Telnet
Sessions (1-4) The maximum number of Telnet sessions allowed to
simultaneously access the agent module.
Physical Address Physical address of the agent module.
Interface Type : Ethernet
IP Address : XXX.XXX.XXX.XXX
Subnet Mask : XXX.XXX.XX.XX
Gateway IP : XXX.XXX.XX.X
IP State : USER-CONFIG
<SAVE> <RETURN> <CANCEL>
3583_11