Enterasys Networks 5H1XX - Manual (Page 57)

Setting the Startup Configuration
Management Setup Menu Screens 6-15
6.6 SETTING THE STARTUP CONFIGURATION
The Startup Configuration screen ( Figure 6-11 ) is used to disable the extended board diagnostics
during the bootup process. When the Startup Diagnostic parameter is set to DISABLED, the
diagnostics will not run and the module will bootup in less time. If the module fails and you need
to run the diagnostics, change the position of dip switch 5 (on the Mode Switch Bank) on the board
and reboot the module. This changes the startup paramenter to ENABLED and forces the
diagnostics to run when the module is rebooted. For information on the location of the switch and
how to set it, refer to the installation guide shipped with your module.
Figure 6-11 Startup Configuration Screen
User Type ADMIN Administrator has access privilege of Read/Write for
all screens.
User Name public Guest has access privilege of Read Only for all
screens.
Password no password Passwords can consist of up to 11 alphanumeric
characters and are not case sensitive. If there is no
password assigned, press ENTER.
Parameter Default Description
Startup Diagnostics : ENABLED
<SAVE> <RETURN> <CANCEL>
3583_19