Enterasys Networks 5H1XX - Manual (Page 69)

Using the Spanning Tree Algorithm
Device Control Menu Screens 7-9
7.4.1 Configuring STA Bridge
The STA Bridge Configuration screen ( Figure 7-5 ) to set the STA Bridge parameters. The
following table describes the STA Bridge configuration parameters.
Figure 7-5 STA Bridge Configuration Screen
Parameter Default Description
Spanning Tree
Protocol ENABLED Enables this parameter to participate in an STA
compliant network.
Priority 32768 Device priority is used in selecting the root device,
root port, and designated port. The device with the
highest priority becomes the STA root device.
However, if all devices have the same priority, the
device with the lowest MAC address will then become
the root device.
Enter a value from 0 - 65535.
Remember that the lower the numeric value, the higher
the priority.
Spanning Tree Protocol : ENABLED
Priority : 32768
Hello Time (in seconds) : 2
Max Age (in seconds) : 20
Forward Delay (in seconds) : 15
<SAVE> <RETURN> <CANCEL>
3583_25