Enterasys Networks 5H1XX - Manual (Page 71)

Using the Spanning Tree Algorithm
Device Control Menu Screens 7-11
7.4.2 Configuring STA for Ports
Use the STA Port Configuration screen ( Figure 7-6 ) to set the STA port parameters. The following
table describe the STA configuration parameters for the ports.
Figure 7-6 STA Tree Port Configuration Screen
Parameter Default Description
Type Shows 10/100TX, 100FX, 1000LX or 1000SX port.
Priority 128 Defines the priority for the use of a port in the STA
algorithm. If the path cost for all ports on a switch are
the same, the port with the highest priority (i.e., lowest
value) will be configured as an active link in the
spanning tree. Where more than one port is assigned
the highest priority, the port with lowest numeric
identifier will be enabled.
The range is 0 - 255.
Spanning Tree Port Configuration :Port 1 - 12
Fast forwarding mode of all ports : [Enable] [Disable]
Port Type Priority Cost FastForwarding
---------------------------------------------------------------------------
1 10/100TX 128 100 ENABLED
2 10/100TX 128 10 ENABLED
3 10/100TX 128 10 ENABLED
4 10/100TX 128 10 ENABLED
5 10/100TX 128 10 ENABLED
6 10/100TX 128 10 ENABLED
7 10/100TX 128 10 ENABLED
8 10/100TX 128 10 ENABLED
9 10/100TX 128 10 ENABLED
10 10/100TX 128 10 ENABLED
11 10/100TX 128 10 ENABLED
12 10/100TX 128 10 ENABLED
<SAVE> <RETURN> <CANCEL> <PREV PAGE> <NEXT PAGE>
3583_26