Epson P-7000 - Manual (Page 91)

2. Connect the AC adapter as shown below, then plug the other end into a power outlet.
* Charge lamp
The Charge lamp lights green during charging. When the battery is fully charged, the Charge lamp
turns off. It takes about 3.5 hours to fully charge the battery when the power is off, more time if the
viewer is in use.
Note:
❏ The viewer stops charging if the battery becomes hot when operating it during charging. In that
case, it starts charging again when it cools down.
❏ If the Charge lamp lights orange, see "Troubleshooting" on page 93.
Removing the battery
1. Make sure that the viewer is turned off.
c
Caution:
❏ Remove the AC adapter if connected.
❏ Never remove the battery while turned on. Doing so may cause data in the card or HDD
to be lost or damaged.
2. Open the battery cover.
R41A0K180 User’s Guide
Maintenance 91