Ericsson STYLUS PRO 4900 - Manual (Page 27)

29
Setting Up the Printer | 29
5. Press OK . A checkmark appears next to SHOW to show that it’s
selected.
6. Press l to go back, then press d to highlight IP ADDRESS SETTING .
7. Press r, then press u or d to choose one of the following IP
configuration settings:
• AUTO: Select this setting if your network uses a DHCP server to
provide IP addresses automatically. The printer’s IP address will be
obtained from the DHCP server whenever the printer is reset or
turned on.
• PANEL: Select this setting if you would like to configure the
printer’s IP settings manually.
8. Press OK . A checkmark appears next to the setting you selected.
9. Press l to go back, then do one of the following:
• If you selected AUTO as the IP ADDRESS SETTING, press the
button to exit the printer menu. Then continue with step 14.
• If you selected PANEL as the IP ADDRESS SETTING, continue
with step 10.
10. Press d to highlight IP, SM, DG SETTING , then press r. The LCD
screen displays the IP ADDRESS .
11. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r . The
LCD screen displays the SUBNET MASK .
12. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r . The
LCD screen displays the DEFAULT GATEWAY .
13. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press OK , then
press the button to exit the printer menu.
14. Turn the printer off, then back on again.
Note: If you don’t know
which setting to use, see
your network administrator
for help configuring the
printer’s IP settings.