Assembly instruction – Escalade Sports F1120 User Manual
Page 7
7
14
15
16R
16L
18
17
10
19
23
22
21
24
19
20
29
STEP 1
1. Connect the FRONT STABLIZER
BAR[ # 14 ] to the MAIN FRAME [ #
19 ] assemble using two CARRIAGE
BOLTS[ #15 ], two CURVED
WASHERS [# 10 ] and two ACRON
NUTS [ #17 ]
2. Repeat the same procedure to connect
the REAR STABLIZER BAR [ #18 ]to
the FRAME ASSEMBLY. Firmly tighten
the four bolts by using CARRIAGE
BOLT [#15] and two CURVED
WASHERS [#10].
3. The PEDALS [#16] are marked “L” and
“R”- Left and Right.
Connect them to their appropriate
Crank Arm [#47]. The right crank arm
is on the right hand side of the cycle as
you sit on it. Note that the Right pedal
should be threaded on clockwise and
the Left pedal on anti-clockwise.
STEP 2
1. Fix the SEAT [# 24] to the SEAT POST
[#21] by using three WASHER [#23]
and three LOCKNUT [#22] located
under the seat, and then insert the
SEAT BELLOW [#29].
2. Insert the SEAT POST [#21] into the
seat post housing and line up the holes
that give the correct seat height. (This
can be done after it has been
assembled.) Secure the SEAT in
position with SEAT-HEIGHT
ADJUSTER [#20]. User can set just
right position to adjust seat-height.
ASSEMBLY INSTRUCTION