Emerson Hot1 - Manual (Page 2)

Wing Nut Mounting Nut Rubber Gasket
Brass Nut
Ferrule
Equipment You May Need:
■ ■
For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing
or using this instant hot water dispenser.
■ ■
This particular unit is not intended for commercial use.
■ ■
Make sure that all electrical wiring and connections conform to local codes.
■ ■
A standard 115-volt grounded electrical outlet is required under the sink for the dispenser’s electrical power.
■ ■
The wall outlet powering your dispenser must have power supplied to it continuously.
■ ■
This outlet must be fused and should not be controlled by the same wall switch that operates the
disposer, unless you have a SinkTop Switch ™ from InSinkErator ® .
■ ■
Moving parts inside the tank causing a rattling noise is normal.
■ ■
This unit does not contain a drain plug and should not be installed where periodic draining is required,
such as summer homes.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Equipment Required:
■
Compression fitting,
T-fitting or saddle valve
■
Adjustable wrench
■ Phillips and flat blade screwdrivers
■
Pencil
■
Tape Measure
■ ■
Hole punch
■ ■
Hole saw
■ ■
Basin wrench
■ ■
Drill
■ ■
Level
If you intend to use the sprayer hole in your sink for your dispenser, you may need a basin wrench and
a 1/8" plug or a 1/4" cap (not supplied) for the faucet spray hose line.
See Step 1-B.
If you need to cut a mounting hole in your stainless steel sink, you may need a 1 1 ⁄
4
" - 1 1 ⁄
2
" hole saw
made for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface
other than stainless steel.
WHAT YOU NEED TO GET STARTED
2
COMPONENTS IN THIS PACKAGE