Electro-Voice Zx1i-90 - Manual (Page 9)

Electro-Voice ® Zx1i Owner’s Manual 9
Step 5: Wire the Speaker
Connect the wires to the speaker using the detachable 4 pole phoenix connector as
illustrated in Figure 10. The 4 connections allow for convenient loop through wiring to
the next speaker system wired in the system.
Step 6: Secure the Seismic Tab Connection Point
The rear of the enclosure includes an eyebolt for connection to a seismic restraint.
Connect it to a properly rated hardware fitting that is securely installed independently of
the SAM™ bracket. Even if your local construction code does not require the installation
of secondary support, its use is highly recommended as additional security.
Step 7: Test System Operation
After all connections are made, test the complete system operation. Appendix A (page
10) contains a troubleshooting table to assist in locating many speaker-related
problems.
Maintenance
Your Zx1™ system has been designed and manufactured to provide years of durability
and reliable service. No routine maintenance is necessary. Units may be cleaned by
wiping with a soft, damp cloth. Never use solvents or harsh cleaning agents of any kind.
Figure 10: Wiring and Seismic Tab Connections
Seismic
Security Cable
Phoenix
Connector
and Wires
Phoenix
Connector
Polarity Detail