Powerplus POW63754 LAWNMOWER 123CC 460MM EN - Manual (Page 13)

POW63754
EN
Copyright © 2013 VARO P a g e | 13 www.varo.com
Engine Displacement / type 123cc, OHV, 4-Stroke engine
Deck material / size
Steel, 480mm (19”)
Blade Width 456 mm
(18”)
Height adjustment: (7 pos ) 20-27-35-45-55-65-75
Central height adjustment yes
Rear discharge yes
Grass collect bag volume 50 Liter
(self trackting)Speed +/- 3.1 km/h
Wheel diameter
Front 175mm (7")
Rear 200mm (8")
Fuel Tank Capacity 1200 ml
Oil tank capacity 600ml
Net Weight (without grass collector) 25.5kg
Net Weight (with grass collector) 30 kg
12 SOUND EMISSION
Noise emission values measured according to relevant standard.
LpA (sound pressure) 84 K = 3 dB(A)
LwA (sound power) 96 K = 3 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
Vibration aw 4.1 m/s² K = 1.5 m/s²
13 STORAGE INSTRUCTIONS (OFF SEASON)
To avoid engine problems, the fuel system should be emptied before storage of 30 days or
longer.
Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty.
Use fresh fuel next season.
Never use engine or carburetor cleaner products in the fuel tank or permanent damage may
occur.
The following steps should be taken to prepare lawn mower for storage.

Following the final cut of the season allow the fuel tank to run dry.

Clean and lubricate mower thoroughly as described in the lubrication instructions.

Refer to engine manual for correct engine storage instructions.

Lightly coat mower's cutting blade with environmental safe chassis grease to prevent
rusting.

Store mower in a dry, clean area.
NOTE:

When storing any type of power equipment in an unventilated or material storage shed, -
Care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the
equipment, especially cables and all moving parts.
 Be careful not to bend or kink cables.
 If the starter rope becomes disconnected from rope guide on handle, disconnect and
ground the spark plug wire, Depress the blade control handle and pull the starter rope out
from engine slowly. Slip the starter rope into the rope guide bolt on handle.