Powerplus POWLI013 PORTABLE HALOG EN FLOODLIGHT 150W EN - Manual (Page 2)

POWLI013 EN
Copyright © 2014 VARO P a g e | 2 www.varo.com
5 USING THE FLOODLIGHT

Simply plug in the cable (E) of the floodlight to the socket.
6 FIXING AND CHANGING A HALOGEN TUBE
 Switch off lamp before installing the bulb.
 Remove screw (A) on top of the lamp and open the cover.
 Push the bulb (B) in between the two prongs. Make sure the prongs are centered on
the metal tips of the bulb, not the ceramic casing.

To avoid premature burn out of the halogen bulb, It is essential to avoid contact with
bare fingers. If need, please clean the bulb with methylated spirits.
 Close cover gently and replace the screw. Never screw cover screw over tight.
7 SPECIFICATION
Type POWLI013
Power 150W
Voltage/frequency 220-240V~50Hz
Bulb type Tungsten halogen tube
Bulb holder R7s
Bulb life-span 1000hours
Floodlight facade material tempered glass
Waterproof protection grade IP44
8 ENVIRONMENT
Should your appliance need replacement after extended use, do not
discard it with the household rubbish but dispose of it in an
environmentally safe way.
Waste produced by electrical machine items should not be handled like
normal household rubbish. Please recycle where recycle facilities exist.
Check with your Local Authority or retailer for recycling advice.