Powerplus POWX1345 MULTI-USE TOOL 300W EN - Manual (Page 5)

POWX1345
EN
Copyright © 2014 VARO P a g e | 5 www.varo.com
 Do not treat the surface to be worked with solvent-containing fluids. Materials being
warmed up by the scraping can cause toxic vapours to develop.
 Exercise extreme caution when handling the scraper. The accessory is very sharp; danger
of injury.
7 ASSEMBLY
WARNING: Always check that the power supply corresponds to the voltage
on the rating name plate. Remove the power tool from the packaging. Do
not plug it into the electrical grid before assembly.
7.1 Mounting sanding plate/ saw blade/ spatula (Fig. 1)
WARNING: Prior to assembly and adjustment always pull out the power
plug from the mains socket.
Take care with sharp tools such as spatulas, saw blades or cutting blades.
 Loosen the clamping plate (b) by pulling the quick-release lever (1) completely open.
 Hold the opening of the quick-install saw blade, sanding plate or spatula toward the output
spindle which between cover clamp (a) and clamping plate (b), push the accessory in and
place it firmly onto the locating pins (c).
 Fasten using the quick-release lever (1) at the lock position as shown in the Fig. 1.
 Remove the accessory in the opposite way.
WARNING: This tool is equipped with quick-install accessories during
operating; do not use any unmatched accessories.
WARNING: Check the tight seating of the application tool/accessory.
Incorrect or not securely fastened application tools/accessories can come
loose during operation and pose a hazard.
7.2 Mounting/changing the sand paper (Fig. 2)
With fast hook and loop fixation.
 Position the sand paper and press by hand.
 Press on the sand paper by giving it a short, firm push against the flat surface of sanding
plate (9) and switch on the power tool.

This ensures good adhesion and prevents premature wear.
 If the point has become worn, pull off the sand paper, turn it through 120º and place it on
again, or change the sanding paper.
7.3 Mounting dust extraction (Fig. 3)
Please follow step 1 until 4.
8 OPERATION
8.1 Switching ON/OFF (Fig. 4)
First check that the cable and plug are not damaged.
 Connect the plug to the power supply.
 Switching the power tool ON: slide ON/OFF switch button (2) forward onto position (I).
 Switching the power tool OFF: slide ON/OFF switch button backward onto position (O).