Machine-specific safety warnings, Powxg5025, 6 machine-specific safety warnings – Powerplus POWXG5025 EARTH AUGER 42,7CC EN User Manual

Page 5

Advertising
background image

POWXG5025

EN

Copyright © 2013 VARO

P a g e

| 5

www.varo.com

 Keep all parts of your body away from any moving part.
 Do not touch area around the muffler or cylinder of the earth auger, these parts get hot

from operation.

 Always stop the engine and remove the spark plug wire before making any adjustments or

repairs except for carburetor adjustments.

 Inspect the unit before each use for loose fasteners, damaged components, fuel leaks,

etc. Replace any damaged parts before use.

 It has been reported that vibrations from hand-held tools may contribute to a condition

called Raynaud’s Syndrome in certain individuals. Symptoms may include tingling,
numbness and blanching of the fingers, usually apparent upon exposure to cold.
Hereditary factors, exposure to cold and dampness, diet, smoking and work practices are
all thought to contribute to the development of these symptoms. It is presently unknown
what, if any, vibrations or extent of exposure may contribute to the condition. There are
measures that can be taken by the operator to possibly reduce the effects of vibration:

 Keep your body warm in cold weather. When operating the unit wear gloves to keep the

hands and wrists warm. It is reported that cold weather is a major factor contributing to
Raynaud’s Syndrome.

 After each period of operation, exercise to increase blood circulation.
 Take frequent work breaks. Limit the amount of exposure per day.
 If you experience any of the symptoms of this condition, immediately discontinue use and

see your physician about these symptoms.

 Keep the tool well maintained, fasteners tightened and worn parts replaced.
 Mix and store fuel in a container approved for fuel.
 Mix fuel outdoors where there are no sparks or flames. Wipe up any fuel spillage.
 Move 9m away from refuelling site before starting engine.
 Stop the engine and allow to cool before refuelling or storing the unit.
 Allow the engine to cod; empty the fuel tank and secure the unit from moving before

transporting in a vehicle.

6 MACHINE-SPECIFIC SAFETY WARNINGS

 Replace augers if cracked, bent, or damaged in anyway. Be sure the auger and or

extension shaft is properly installed and securely fastened. Failure to do so can cause
serious injury.

 Make sure all guards, straps, deflectors and handles are properly and securely attached.
 Do not start working until you have a clear work area. Do not work near electric cables or

underground utilities. It is highly recommended that you check with local authorities before
starting to drill.

 If auger turns whilst the engine is idling, stop the engine and immediately adjust the idle

settings following the instructions in this manual.

Use only the manufacturer’s replacement augers on this unit. Do not use any other
attachments.

 Never operate unit without the safety clutch in working condition. The safety clutch will

engage when the engine is at idle or if a hard object is struck.

 Replace the bit immediately if any cracks or other damage are present.
 Maintain a firm grip on both handles during operation.
 Never use the drill with the handles above waist level. Drilling with the units handles above

waist level restricts control and can cause serious chest injuries if a hard object is struck.

 Never carry the power drill with the engine running.
 Carry the power drill with the engine stopped, and with the auger bit removed.
 Never drill in a horizontal angle. This drill should only be operated with the auger at a 90°

angle to the ground (see figure 7a).

 Always keep the handles dry and clean.

Advertising