Powerplus POWXQ5234 IMPACT DRILL 18V EN - Manual (Page 8)

POWXQ5234 EN
Copyright © 2012 VARO NV P a g e | 8 www.varo.com
temperature.
When the battery is fully charged, unplug your charger from the power supply and remove
the battery pack from the charger.
CAUTION:
To prevent damage to the battery pack, remove the battery pack immediately from the
charger when no LED illuminates. Return battery pack and charger to your dealer for
checking or replacing.
Do not insert a battery pack into a damaged charger, it may damage your battery pack.
9.2 Install/remove battery pack.
9.2.1 To install battery pack on your cordless drill
Lock the switch trigger (4) on the drill by placing the forward/reverse) selector in its centre
position. Place the battery pack in the drill. Align the raised rib on battery pack with the
groove inside the drill. (Make sure the latches on each side of your battery pack snap in
place and battery pack is secured in the drill before beginning operation.)
9.2.2 To remove battery pack
Lock the switch trigger on the drill by placing the forward/reverse) selector in its centre
position. Locate latches (9) on the side of the battery pack and depress them to release
the battery pack from the drill.
The battery pack will automatically disconnect in the direction it should be removed in.
Remove the battery pack from you drill.
9.3 Switch
The drill is started and stopped by depressing and releasing the switch trigger.
Release the switch trigger to turn the drill OFF, in short time because of electric brake.
9.3.1 Switch lock
The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental starting when not in use. To lock the
switch trigger, place the direction of rotation selector in the center position.
9.3.2 Direction of rotation
The direction of rotation is controlled by the direction of rotation selector located above the
switch trigger.
With the drill held in normal operating position, the direction of rotation selector should be
positioned to the left of the switch for drilling. The rotation direction is reversed when the
selector is to the right of the switch. When the selector is in the center position, the switch
trigger is locked.
9.3.3 Variable speed
This tool has a variable speed switch that delivers higher speed and torque with increased
trigger pressure.
Speed is controlled by the amount of switch trigger depression.