Powerplus POW306002 DRILL/SCREWDRIVER 14.4V 2BATT EN - Manual (Page 6)

POW306002 EN
Copyright © 2012 VARO P a g e | 6 www.varo.com
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
§ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
§ Regularly clean the machine housing with a soft cloth, preferably after each use.
§ Keep the ventilation slots free from dust and dirt.
§ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Battery voltage 14.4V
No load speed 0-550min
-1
15 + 1 positions torque /drill
Keyless chuck 10mm
Ni-Cd battery – 800mAh
Charger 230 V – 50Hz
Charging time 3- 5hours (MAX)
11 NOISE EMISSION VALUES
Noise emission values measured according to relevant standard.
Acoustic pressure level LpA 69 dB(A) K = 3 dB(A)
Acoustic power level LwA 80 dB(A) K = 3 dB(A)
ATTENTION! The sound power pressure may exceed 85 dB(A), in this case
individual hearing protection must be worn.
aw (Vibration) 0.2 m/s² K = 1.5 m/s²
12 SERVICE DEPARTMENT
§ Damaged switches must be replaced by our after-sales service department.
§ If the connecting cable (or mains plug) is damaged, it must be replaced by a special
connecting cable which is available from our service department. Replacement of the
connecting cable should only be carried out by our service department (see last page) or
by a qualified specialist (qualified electrician).
13 STORAGE
§ Thoroughly clean the whole machine and its accessories.
§ Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
§ Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
§ Don’t keep it in plastic bags to avoid humidity build-up.