Powerplus POW411 BELT SANDER 800W EN - Manual (Page 6)

POW411 EN
Copyright © 2013 VARO NV P a g e | 6 www.varo.com
8 TROUBLESHOOTING
In case the belt sander does not work well, we give you some possible causes and solutions.
Problem Cause remedy
The electromotor gets
hot The cool ventilation slots in the
motor are stopped up with dirt Clean the cool ventilation
slots
The connected machine
does not work Interruption in the mains
connection Check mains connection
for fracture
The dust is not
absorbed This can be caused by a
stopped up dust extraction Clean your dust collection
opening
9 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Voltage / frequency 230V / 50Hz
Power input 800 W
No load sander paper speed 290 m/min
Sanding belt size 76 x 457 mm
Insulation class (Double insulated) II
Weight 3.1 kg
Degree of protection IP20
11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA 93 dB(A) K = 3 dB(A)
Acoustic power level Lw 104dB(A) K = 3 dB(A)
ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).
aw (Vibration): 4.7 m/s² K = 1.5 m/s²
12 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).