Extending the cords by hand, Changing the cord, Remove the cord spool (fig 3) – Powerplus POW6010P GRASS TRIMMER 250W 200MM EN User Manual

Page 8: Replace the cord in the cord spool, Insert the cord spool, Technical data, Noise

Advertising
background image

POW6010P

EN

Copyright © 2014 VARO

P a g e

| 8

www.varo.com

8.6

Extending the cords by hand

If the cords have already become too short they will not extend by tapping. You must pull them
out of the cord spool by hand.
 Lay the product on the ground.
 Press your hand on the bottom of the spool and pull the two cords out until they are

slightly longer than the edge of the protective shield.

 The cords are cut to the right length by the cutting knife when used again.

8.7

Changing the cord

It is possible to replace the entire cord spool or just the cord.

8.8

Remove the cord spool (Fig 3)

 Unscrew the lock
 Remove the cord spool.

8.9

Replace the cord in the cord spool

 Remove cord residues from the cord spool.
 Roll up the cord in the cord groove.

8.10

Insert the cord spool

 Insert the cord spool back into the cord spool housing and turn until the spool is firmly

seated.

 Pull out both cords and thread into the cord guide.
 Close the lid and screw the lock down tightly.
 When used for the first time,the knife automatically cuts the cords to the right length.

9 TECHNICAL DATA

Rated voltage

230V

Rated frequency

50Hz

Rated Power

250W

No load speed

14000min

-1

Cutting width

200mm

Line size

Φ1.2mm

Cutting system

2 lines/tap & go

Weight

1,3kg

10 NOISE

Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA

76 dB(A)

Acoustic power level LwA

96 dB(A)

ATTENTION! Wear hearing protection when sound pressure is over 85
dB(A).

aw (Vibration):

Max 8.0 m/s²

K = 1.5 m/s²

Advertising
This manual is related to the following products: