Powerplus POW60476 BRUSH CUTTER 32.6CC EN - Manual (Page 7)

POW60476 EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
The cutting blade may be removed in the opposite sequence.
Attention! The cutting blade's drill hole diameter must exactly match the
turntable diameter.
8 FUEL AND LUBRICATION
8.1 Fuel
Use unleaded gas mixed with 2-cycle engine oil in the ratio 25:1. It will guarantee the unit's
optimum performance.
Caution! Do not ever use pure gasoline in your unit. It could permanently
damage the engine and exclude warranty claims concerning this product.
Never use a fuel mixture, which has been stored for more than 90 days.
Caution! Use only first class 2-cycle oil mixed in the ratio 25:1. Do not use
2- cycle oil with the recommended mixing ratio 100:1. In case of damage
caused by insufficient lubrication no warranty claims will be possible.
8.1.1 Mixture of gasoline and oil in the ratio 25:1
First of all, pour oil into the fuel tank and than add gasoline in order to mix it with the oil. Shake
the tank properly in order to reach a good mixture.
Caution! Insufficient lubrication excludes warranty claims. Gasoline and oil
must be mixed in the ratio 25:1.
9 OPERATION
9.1 Unit operation
Attention! Do not use the unit with out its protective cover. Always check
the unit's condition before you use it.
Before setting the unit into operation, check the unit's safety, especially for:
 On/Off stop control
 Gas lever and its holder
 Operation of protective devices
 Firmness, damage, and worn-out cutting components
 Grips/handles - must be clean and dry
9.2 Use of the belt
 Equip the attached harness.
 Turn on the engine, return the throttle lever to the lowest speed position, and put the
harness hook to the hanging part of the machine.
 Adjust the length of the harness so that the blade may be parallel to the ground in the
working position. In order to prevent slack during operation, turn up to ensure the extra
length of the band and not loose.
9.3 Engine starting (cold engine)
Attention! Never start the engine near the refueling site.