Powerplus POW63707T LAWNMOWER 1100W 330MM +TRIMMER EN - Manual (Page 12)

POW63707 EN
Copyright © 2010 VARO P a g e | 12 www.varo.com
13 SERVICE DEPARTMENT

Damaged switches must be replaced by our after-sales service department.

If the connecting cable (or mains plug) is damaged, it must be replaced by a special
connecting cable which is available from our service department. Replacement of the
connecting cable should only be carried out by our service department (see last page) or
by a qualified specialist (qualified electrician).
14 STORAGE
Always clean your mower before storage. Store your mower in a clean, dry environment.
To avoid mould on remaining contents, make sure the grass collect bag is empty and dry.
You can fold the handle to save space, loosen the 2 clamps on each side of the handle and
bend the upper handle part towards the front of the machine.
14.1 Long time storage:
Apply some environmentally friendly oil on the mower blade to prevent it from rusting.
14.2 Hibernation
Have your blade sharpened after the mowing season, so your machine is ready for the new
season.
15 TROUBLE SHOOTING
Problem Cause Action
Machine fails to operate
Power turned off

Mains socket faulty

Extension cable
damaged

Fuse faulty/blown

Mower in long grass

Motor protector has
activated

Turn power on

Use another socket

Inspect cable, replace if
damaged

Replace fuse

Increase height of cut
and tilt mower

Allow to cool and
increase height of cut
Machine functions
intermittently
Extension cable
damaged

Machine’s internal wiring
damaged

Motor protector has
activated

Inspect cable, replace if
damaged

Allow to cool and
increase height of cut
Machine leaves ragged
finish
Or motor labours
Height of cut too low

Cutting blade blunt

Underside of machine
badly clogged

Blade fitted upside down

Increase height of cut
(see “Height of Cut
Adjustment”)

Replace blade (see
“Blade Maintenance”)

Clean machine (see
“After Mowing/Storage”)

Refit blade correctly
(see “Blade
Maintenance”)
Cutting blade not rotating
while machine switched on
Cutting blade obstructed

Blade nut/bolt loose

Clear obstruction

Tighten blade nut/bolt
Excessive vibration/noise
Blade nut/bolt loose

Cutting blade damaged

Tighten blade nut/bolt

Replace blade