Eaton Electrical ESWA6500SC - Manual (Page 3)

PRELIMINAR
Y DRAFT
Proof #3 — Zoltun Design — May 2, 2006
EATON CORPORATION Cutler-Hammer Wall and Ceiling Mounted Speakers Installation Manual IM00412012E ா Copyright 2006 3
Speaker Installation (continued)
Make sure that the speaker is level and carefully tighten the mount-
ing screws to secure the speaker. As you tighten the screws, the
mounting bracket feet will flip into position to grip into the drywall. Do
not over tighten the mounting screws.
Mounting Brackets Opened to Grip Into Drywall
Adjusting Swivel Tweeters
The adjustable, swivel tweeter allows you to direct mid-range and
high-range frequencies towards or away from the listening area.
Speaker With Adjustable Swivel Tweeters
To adjust the position of the tweeter, gently apply pressure on the
edge of the tweeter housing toward the desired area.
Caution : Too much pressure during this procedure can cause
damage to the tweeter.
Adjusting the Tweeter
Reapplying the Speaker Grill
Once the tweeters are adjusted, the grill can be replaced. Recheck
that the speaker is level. Gently press the speaker grill into the
grooves on the speaker frame. Be sure to apply pressure evenly as
you press the grill into place. Uneven pressure can cause damage to
the grill.
Push Evenly the Grill Back Onto the Speaker Frame
Setting Level Controls
To achieve desired sound, set tweeter levels first, then match bass
output.
If only two channels (R & L) of your amplifier are driving more than
one pair of speakers, Eaton suggests using the lowest output posi-
tion for the woofer until you can make sure the amplifier can handle
the additional woofer settings.
Painting the Speaker
Speaker Grill: Remove the speaker grill from the speaker frame.
Paint the grill lightly, being careful not to clog the holes. Do not paint
the grill while it is still on the speaker.
Speaker Frame: Eaton suggests painting all parts of the speaker
prior to the installation. If you must paint after installation, place the
provided paint guards around the grill area. After the paint guards are
in place, paint the frame of the speakers.
Tightening all
the screws will
flip the
mounting
brackets into
the open
position to grip
drywall.
Adjustable
Swivel Tweeter