Powerplus POWX350 PAINT SPRAY GUN 120W EN - Manual (Page 8)

POWX350 EN
Copyright © 2011 VARO P a g e | 8 www.varo.com
9 TECHNICAL SPECIFICATIONS
Voltage 230-240V
Frequency 50Hz
Power input 120W
Maximum nozzle flow rate 320 gr/min
Container capacity 800 ml
Nozzle diameter 0.8 mm
Max viscosity 50din/sec
10 SOUND EMISSION
Noise emission values measured according to relevant standard.
Acoustic pressure level LpA
88 dB(A) K = 3 dB(A)
Acoustic power level LwA 101 dB(A) K = 3 dB(A)
ATTENTION ! The sound power pressure may exceed 85 dB(A), in this case
individual hearing protection must be worn.
aw (Vibration) 18,60 m/s² K = 1,5 m/s²
11 TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
Motor hums but
does not spray or
irregular spraying.
Worn swirl head

Pick up pipe not in the right
position

Blocked pick up pipe

Blocked nozzle

Blocked filter

Control knob needs adjustment

Replace swirl head.

Re-adjust pick up pipe.

Clean with thinner.

Clean nozzle.

Clean with thinner.

Adjust.
Atomization is not
good.
Volume adjustment is not
correct.

Paint too thick

Adjust.

Check viscosity of the paint.
Over painting.
Spray gun not clean, or not
lubricated resulting in piston
being stuck in cylinder

Too much paint

Viscosity too low

Disassemble spray gun and
clean with thinner.

Adjust the volume clockwise to
reduce spraying. Two thin coats
are better then one

Check viscosity
Motor louder than
normal.
Spray gun not clean, or not
lubricated, resulting in piston
being stuck in cylinder

Disassemble spray gun and
clean with thinner.
No spray, no
sound.
No electricity
Check power supply
Operating sound
not right.
Poor output adjustment

Not enough paint in the
container resulting in air being
sucked in.

Not diluting properly or not

Re-adjust

Refill with paint.

Check pick up pipe and
viscosity level.