Powerplus POWXG4050 LEAF BLOWER/VACUUM 31CC EN - Manual (Page 6)

POWXG4050 EN
Copyright © 2013 VARO P a g e | 6 www.varo.com
9 USE
9.1 Fueling
MOTOR FUEL: mix the petrol and oil at 40:1only – 2 stroke
 Use fresh unleaded petrol. You must use 100% synthetic oil specifically made for heavily
stressed two stroke engines.
 Mix the petrol and oil in an approved container. Never mix fuel directly in the line trimmer
fuel tank.
 Place the brush cutter upright on the ground or on a sturdy bench and wipeany debris
from around the fuel cap.
 Unscrew the fuel tank cap and pour the mixture into the tank with the aid of a funnel.
 Be careful not to spill any mixture. If this happens, wipe the spill with a clean rag.
 Start the engine at least three metres away from the area where the fuel tank has been
filled up in order to avoid any risk of fire.
9.2 Use
To reduce the risk of injury, safety switches are installed for the nozzle and
quick release collect bag. The Blower/Vac can not be turned on unless the
nozzle and quick release collect bag are attached.
1.Set the mode selection lever (7) to the
right position Ensure the level have clicked
to place and is rotated to the furthest point.
2.Push the switch (6) to power on marked
“I”.