Technical data, Trouble-shooting, Powxg6490 – Powerplus POWXG6490 LOG SPLITTER 1500W 520MM EN User Manual

Page 9: 9technical data, 10 trouble-shooting

Advertising
background image

POWXG6490

EN

Copyright © 2014 VARO NV

P a g e

| 9

www.varo.com

9

TECHNICAL DATA

Rated Voltage

230V

Rated Frequency

50Hz

Rated Power

1500W (S3: 5min On 5min OFF)

Rotation speed

2800min

-1

Max. Log diameter

30-250mm

Max. Log lenght

520mm

Work force

5Ton

Max hydraulic pressure

20MPA

Power supply

230V~ /50Hz


Remark : log dimensions

The firewood diameter given above is an
indication. Even though a log may not be too
large, it can be difficult to split. Knotty, very dry
wood or hard wood may be more difficult to split.
Soft wood is easier to split, so it might be
possible that even larger diameters in softwood
can be split.

Caution: If a log does not split right away, stop pressing, because the
hydraulic may overheat, causing damage to the pump.

10 TROUBLE-SHOOTING

Dislodge lodged wood as follows:
 Push the push plate completely back by fully releasing the operating handle.
 Place a wooden wedge squarely under the placed log. Push the push plate in such a way

that the wedge comes to rest directly below the stuck log.

 If this does not dislodge the log, use a larger wedge, and activate the push plate until the

log is dislodged.

CAUTION:
 There must never be two persons by the log splitter when a lodged log needs dislodging
 Wood that is stuck should never be hit off or blocked in an attempt to release it, as the

engine block can break.

All safety provisions in chapter ‘General Safety Provisions” must be observed when
carrying out this operation. The manufacturer shall not be responsible for material damage
or injury to persons or animals caused by improper use or by noncompliance with the
safety provisions.

Advertising