Powerplus POWXG8035LI TELESCOPIC HEDGE TRIMMER 18V LI-ION ONE FITS EN - Manual (Page 7)

POWXG8035LI EN
Copyright © 2014 VARO P a g e | 7 www.varo.com
8 OPERATION
Warning! Before performing any work on the equipment, always remove the
battery.
8.1 Adjust the cutting length
 Pull the adjust rigger (5)
 Push poles toward each other to shorten the pole or pull away from each to lengthen the
pole.
 When the desired length is achieved, press the adjust trigger back.
8.2 Adjust the cutting angle
 Press the rotating knob (4)
 Adjusting the cutting head to a comfortable position.
 Release the knob.
8.3 Starting and stopping the machine
 To start the tool: press the safety button (11) and then press the trigger (12). Release the
safety button once the motor has started.
 To stop the trimmer: Release the trigger.
8.4 Assemble the shoulder belt
 Wear the shoulder belt so that it lies over the right shoulder or left shoulder.
Do not let the shoulder belt cross tyour body!
 Fasten the snap hook on the shaft bracket on the shaft.
9 CUTTING TIPS
 Assume a secure position, using two hands to hold the trimmer and switch on.
 Trim both sides of the hedge, starting at the bottom. This prevents cuttings falling into the
area yet to be cut.
 Pass the blade lightly through the surface of the hedge. Do not attempt to cut too deep.
 Trim the top of the hedge.
 For older hedges that require cutting back substantially, use pruning shears to cut the
thicker branches and then finish the job with the hedge trimmer.
 Never use the hedge trimmer without check the tightness of the bracket.