Eiki/Elf EIP-4500 - Manual (Page 20)

20
Setting up the Projector Network Environment
1
2
After confirming or setting, proceed to “3. Setting up Network Connection for the
Projector”.
5
Click “Internet Protocol (TCP/IP)”,
and click the “Properties” button.
6
Confirm or change an IP address
for the setup computer.
1 Confirm and note the current IP
address, Subnet mask and Default
gateway.
Make sure to note the current IP
address, Subnet mask and Default
gateway as you will be required to re-
set them later.
2 The factory default setting for the pro-
jector IP address is “192.168.150.2”,
Subnet mask is “255.255.255.0” and
Default gateway is “0.0.0.0”.
Set temporarily as follows :
IP address : 192.168.150.3
Subnet mask : 255.255.255.0
Default gateway : (Do not input any
values.)
7
After setting, click the “OK” but-
ton, and then restart the com-
puter.