Excalibur electronic Motorized Bumper Boat with Squirt Gun PR11BK-2 User Manual
Page 5
7. Hold the Bumper Boat verti-
cally. This will make it easier for
the final steps of the assembly.
Insert the control arm sleeve set
into the hole located at the front-
center of the Bumper Boat.
8. Insert the electrical connection
line into the motor subassembly
that encloses the propeller.
9. Insert the control arm through
the top of sleeve set. Insert the
electrical line through the bottom
of the control arm sleeve set.
10. From the bottom of the
Bumper Boat, you can see the
“1” printed on both sides of the
control arm and propeller.
11. Push the connection up and
make sure that it is tightly secured
into the propeller.
12. You have finished assembling
the Bumper Boat.
13. After step 12, insert the air
pump and inflate the small cavity
in the middle of the Bumper Boat
until firm.
5