Enterasys Networks ENTERASYS ATX User Manual
Page 57
Editing the Port Filters Table
4-7
Using ATX Port Filtering
2.) Click to de-activate (gray-out) the Not In Range check box if you want
to filter on source address values within the specified range. This is
the default.
c.
Click in the Mask: text box and type in an address mask value that you
want to apply to the source address range. (The default is all FF’s. An F in
the mask indicates that you want to match the corresponding bit within the
address range; a 0 in the mask indicates a “don’t care” bit. For example, a
mask of FF:FF:FF:F0:00:00 indicates that you want to decode the 6-byte
address to the seventh bit, and you don’t care about the remaining five
bits).
d.
Click in the Begin: text box, and type in the source address that you want
to use as the initial entry within the range (in hexadecimal
XX:XX:XX:XX:XX:XX format, where the value of XX ranges from 00-FF).
e.
Click in the End: text box, and type in the source address that you want to
use as the final entry within the range (in hexadecimal
XX:XX:XX:XX:XX:XX format).
6.
To use a range of Destination Addresses as a filter criteria:
a.
In the Filter Parameters section, click on the Destination Address
Range check box to activate the Destination Address Range text fields.
b.
Indicate whether you want the specified address range to be exclusive or
inclusive for filtering purposes.
1.) Click to activate (highlight) the Not In Range check box if you want to
filter on any destination address outside of the specified range.
2.) Click to de-activate (gray-out) the Not In Range check box if you want
to filter on destination address values within the specified range. This
is the default.
c.
Click in the Mask: text box and type in any mask value that you want to
apply to the destination address range.
d.
Click in the Begin: text box, and type in the destination address that you
want to use as the initial entry within the range (in hexadecimal
XX:XX:XX:XX:XX:XX format, where the value of XX ranges from 00-FF).
e.
Click in the End: text box, and type in the destination address that you
want to use as the final entry within the range (in hexadecimal
XX:XX:XX:XX:XX:XX format).