Emerson 5-In-One Learning Light-Up Remote - Manual (Page 10)

10 Preparation
3. On the remote control, press the desired device key
( TV , VCR , CBL/SAT , DVD , or AUX ).
Note: For TV/VCR combinations, press VCR and
use the VCR code listed for your model under “TV-
VCR Combo Codes” on Page 38. If your TV/VCR
combination also lists a TV code, you must program
the TV separately by repeating Steps 3–5 to add
volume control. In Step 3, press
TV , then in step 4
enter the TV code.
4. Hold down P until the remote’s red light blinks twice,
then release P and enter the first 4-digit manufac-
turer’s code for the desired device. When the red
light blinks twice, the remote control has accepted
the code.
For example, to set up the remote control of a Pana-
sonic TV (manufacturer’s code 0051), press
TV ,
hold down P until the red light blinks twice, release P
and press 0 0 5 1 .
Note: If you entered the code incorrectly, the red
light emits one long blink.
5. Point the remote control at the desired device and
press POWER . The device should turn off.
If the remote control does not operate your device,
try the other codes listed in “Manufacturers’ Codes”
for your type and brand of device. Otherwise, use
the search method to find a working code — see
“Using Manual Code Search” on Page 20.
6. Repeat Steps 2–5 to program other devices.
Note: If the remote control does not operate all
device functions, try using another code in the list
that may be more compatible.
PROGRAMMING FAVORITE CHANNEL
SCAN
Once you have programmed channels into a favorite
channel table, you can scan up to ten favorite channels
for a desired device.