Epson Express Station - Manual (Page 22)

Connecting the Power Cord
When you finish connecting all of your peripheral devices,
connect the computer’s power cord to the power inlet.
Then plug the other end of the cord into the electrical outlet. Be
sure to read the next section before you turn on the computer.
Turning On the Computer
Before you turn on your system, read the following safety rules
to avoid damaging your computer or injuring yourself:
Do not connect or disconnect any power or peripheral
device cables when the computer’s power is on.
Never turn on the computer when its cover is off.
Never turn off or reset your computer while a disk drive
access light is on. This can destroy data stored on the disk.
Always wait at least five seconds after you turn off the
power before you turn it on again. This prevents possible
damage to the computer’s electrical circuitry.
Do not leave a beverage near your system or any of its
components. Spilled liquid can damage the circuitry of
your equipment.
Setup
Guide 13