Epson 51c - Manual (Page 30)

Using the Projector 25
What To Do If You See a Blank Screen
If you see a blank screen or a blue screen with the message No Signal
after turning on your computer or video source, do one of the
following:
■ Make sure the cables are connected correctly, as described in
Chapter 1.
■ Make sure the Power light is green and not flashing and the
lens cap is off.
■ If you’ve connected more than one input source, you may need to
press the
Source button on top of the projector or the
Computer , Video , or S-Video button on the remote control to
select the source you want to use. (Allow a few seconds for the
projector to sync up after pressing the button.)
■ Try restarting your computer.
■ If you still don’t see an image and you’re using a PowerBook, see
page 26 or 27 for additional steps. If you’re using a PC laptop,
see page 28.
Source button
Computer,
Video, and
S-Video
buttons